Applies Clear, Dries Clear
Strong and Durable
Heat and Water Resistant
What materials is this product suit for?
How To Use
How to use this product?
Ensure surfaces are clean and dry. If cutting laminate sheets, cut slightly oversize. Tube: Remove cap and carefully pierce foil seal.
For porous surfaces apply a thin coat to seal surface and allow to dry for approximately 40 minutes.
Apply to both surfaces and spread evenly ensuring surfaces are completely covered. Keep surfaces apart until adhesive is almost dry – approximately 15 minutes, no more than 30 minutes.
Position items carefully, still keeping surfaces apart with dowels. When edges are perfectly aligned, remove dowels, and working from one edge, press surfaces firmly together. Grabs immediately on contact.
Secure bond by running a roller over the bonde3d surfaces or by hammering the surface from the centre outwards using a padded block. Maximum bond strength is reached after 24 hours. Clamping of warped or curled surfaces may be necessary.
WET BONDING (Small areas or porous surfaces)
Ensure surfaces are clean and dry.
Apply Kwik Grip? to one surface, then bring surfaces together and clamp until dry.
Ensure compatibility with materials to be bonded, test on an inconspicuous area or confirm with the materials manufacturer (e.g. some vinyl floor coverings are incompatible with solvent products).
Do not use below 10°C.
Ensure contents are completely dry before disposing.
Not for polyethylene, polypropylene plastics.
Keep out of reach of children.
Avoid contact with skin and eyes. In case of eye contact, immediately flush with water and wash skin with soap and water.