Bonds a variety of surfaces**
Dries Clear for clean, neat results
No mixing required
5 minutes for initial bond, 30 minutes for sufficient bond strength for practical use.
Maximum bond strength reached in 12 hours
Non-drip gel consistency is ideal for vertical surfaces
More time to arrange & reposition
No immediate finger bonding*
* Adhesive will stick to skin, but this is delayed 20 – 30 secs, depending on skin type and amount of adhesive
** Not recommended for Teflon, polyethylene, polypropylene plastics, glass, items that contain hot liquids. May cause leather to discolour or harden, if in doubt test on a small hidden area first.
What materials is this product suitable for?
*** Pre-test plastics to determine compatibility
How To Use
How to use this product
Ensure surfaces to be bonded are clean, dry, free of dust and close fitting
Remove nozzle and pierce tube seal with reverse end of cap and replace nozzle.
Remove cap and apply a small amount of glue to one surface. Bring surfaces together and apply slight pressure. Allow 30 minutes for sufficient bond strength for practical use. Maximum bond strength reached after 12 hours
Keep out of reach of children.
Avoid contact with skin and eyes and avoid breathing in vapour.
Bonds on contact. Should fingers stick together apply a solvent such as acetone (nail polish remover to contact areas then wash with water.
DO NOT use solvents near eyes or open wounds. In case of eye contact immediately flush with water for at 15 minutes and seek medical advice
NOTE: This product is not hazardous once cured.
Wipe tip of tube, replace cap and store upright in dry cool place